Page 1 of 1
Size of Drill Bit for holes on a homebuilt Hesslerk Altoid A
Posted: Sun May 24, 2020 8:23 pm
by iKokomo
I just built a Hesslerk Altoid, however, his shop is closed so I cannot ask him these questions. I was wondering what size drill bit that I would need to drill the holes for the volume/power knob, 1/4th and 3.5mm jack? They are marked on the photo with the red arrows.
Re: Size of Drill Bit for holes on a homebuilt Hesslerk Alto
Posted: Thu Oct 22, 2020 12:54 pm
by K-Bizzle
If you've got the parts already all you need is a caliper and you'll be able to answer your own question.
Re: Size of Drill Bit for holes on a homebuilt Hesslerk Alto
Posted: Tue Feb 23, 2021 8:55 am
by fretless
I'm pretty sure time travel is possible , it's like folding a pizza .